Furuno FAR-2107 Series Service Manual page 326

ALARM OUT 1, 2, 3, 4
TARGET ALARM
WATCH ALARM
GUARD ZONE
LOST TARGET
CPA LIMIT
AUTO ACQ TAG
FULL
MAN ACQ TAG
FULL
ARP SYSTEM
ERROR
AZIMUTH
HEAD LINE
TRIGGER
VIDEO
GYRO
LOG
(LOG/EPFS)
EPFS
XTE
ARRIVAL WPT
DEPTH
ALARM ACK OUT
OPERATOR
FINESS
ALARM-1, 2: When applicable target within the TARGET
ALARM setting range is detected
Target alarm
When WATCH ALARM is set and the set time has been reached
Watch alarm
When applicable target within the Guard Zone set in GZ-1 and 2
Guard
is detected
When the ARP target is lost (Even if the AIS target is lost, it is not
Lost
outputted from ALM-1 to ALM-4.)
CPA When the setting targets in [CPA] and [TCPA] boxes are detected
The number of auto
When the number of automatically acquired targets set in [ARP]
acquisition targets icon menu is reached
The number of
When the number of manually acquired targets set in [ARP] icon
manual acquisition
menu is reached
targets
ARP system error When ARPA CPU stops
Anatenna
When BP from antenna cannot be detected on the SPU board
revolution signal
Heding line When HP from antenna cannot be detected on the SPU board
When BP stops on the SPU board and trigger stops in normal
Trigger
operation
Video When video signal from the TR unit can not be detected
When Gyro signals from [HDG SENSOR] and [GC-10] port
cannot be detected (AD format signal, HDT) or the gyro data is
Gyro
abnomal. *When the AD data is re-inputted, "HEAD SET" is
displayed. Adjust heading data, then change the Display mode.
When LOG (BT) or LOG (WT) is selected in 1: SHIP SPEED of
Log
[SPD] box menu but the ship speed data is not inputted.
- When GPS1 or GPS2 is selected in 1: NAV AID of [OS POSN]
- When GPS is selected in 1:SHIP SPEED of [SPD] box menu but
Positioning system
- Only IMO type
Deviation from When set in "[Menu]->8->5:NAV LINE WIDE" the ship's position
NAV line is out of NAV line width. (e.g. from DGPS to GPS)
When entering the range set in [Menu]->8->4:ARIVALE WPT
Arrival at waypoint ALARM ship approaches to the waypoint within the range is out of
NAV line width. (e.g. from DGPS to GPS)
When the water depth is shallower than the setting in [Menu] -> 7
Water depth
-> 4:DEPTH MARK
ALARM ACK
When [ALALM] key is pressed, "ALARM" is turned on for a
OUT second
Outputted every 5 seconds during operation
OPERATOR
FINESS
Table 4.11.3 ALARM Output Setting
Note:
[Menu]->3->2:GURD ALARM MODE (IN/OUT)
[Menu]->3->3:GURD ALARM LEVEL (1-4)
Note:
[Menu]->3->4:WATCH ALARM (OFF/6/10/12/15/20 min)
box menu but position data is not inputted
ship speed data is not inputted from GPS
When GPS accuracy is changed
Note: When OPERATOR FINESS setting is ON, other ALM
setting is all canceled.
4-62
4.11 Alarm Output Setting
Remarks