Furuno FAR-2107 Series Service Manual page 265

When you change the setting of a menu or on-screen icon menu, wait for six
seconds or more before tuning off the power. If the power is turned off in less
than six seconds, the data is not saved in the flash memory. After changing the
INSTALLATION and FACTORYmenu, restart the power.
4.1 Optional Menus
Item
Cancel the 3 minutes delay
Note
function
INITIALIZE menu
(Call up the INITIALIZE
menu)
FACTORY menu
(Call up the FACTORY menu)
Monitor brilliance
Note: When the INITIALIZE menu or FACTORY menu is called up, the menu is
retained until the power is turned off.
If the power is turned on immediately after the power off, 3 minutes delay
counting is abbreviated.
Execute FACTORY DEFAULT by RCU-014
1. Call up the [FACTORY] menu.
While holding down the [1:HL OFF] key, press [2], [3] and [4] keys in order.
2. The [FACTORY] menu will be displayed. Select "3. FACTORY DEFAULT" and
press the [ENTER] key 5 times.
3. Turn off the power when the message "Wait now Formatting..." followed by
"Completed!! Power on Restart" is shown.
Execute FACTORY DEFAULT by RCU-015 and RCU-016
1. Call up the [FACTORY] menu.
Press the [F2], [F3] and [F4] keys in order while holding down the [F1] key.
2. The [FACTIRY] menu will be displayed. Select "3. FACTORY DEFAULT" and
click the left button of the track ball 5 times.
3. "Wait now Formatting..." is shown. After a while "Completed!! Power on Restart"
is shown, and then turn off the power.
Chapter 4. System Setting
RCU-014
Press the [ENTER] key 5
times while holding down the
[1:HL OFF] key.
Press the [MENU] key 5
times while holding down the
[1:HL OFF] key.
Press the [2], [3] and [4] keys
in order while holding down
the [1:HL OFF] key.
Adjust of [BRILL] VR
4-1
4.2 Overview of [FACTORY] Menu
Table 4.1.1 List of Optional Menus
Operation
RCU-015, 016
Place the cursor on STBY-TX and
click the right button of the track
ball 5 times while holding down
the [F1] key.
Place the cursor on the menu and
click the right button of the
trackball 5 times while holding
down the [F1] key.
Press the [F2], [F3] and [F4] keys
while holding down the [F1] key.
The brilliance is set to 50 when
one key of [F1] to [F4] keys is
pressed for longer than 4 seconds.