Furuno FAR-2107 Series Service Manual page 237

1 BACK
2 GURD ALARM MODE
3 GURD ALARM LEVEL
4 WATCH ALARM
3 [ALARM]
5 ALARM SOUND LEVEL
6 [ALARM OUT1]
7 [ALARM OUT2]
8 [ALARM OUT3]
9 [ALARM OUT4]
0 ANCHOR WATCH
1 BACK
2 GURD ZONE STAB
3 GURD POLYGON
4 [TRIAL MANEUVER]
4 [ARP/AIS]
5 [ARPA SYMBOL]
6 [AIS SYMBOL]
7 [FUSION]
Cont'd
Turns on and off an alarm to be given when the target
inward or outward the alarm range set in ALARM 1 and 2.
Adjusts the target echo level. It is dependent on the
adjustment of GAIN, STC and FTC. The setting "1", the
lowest echo detection level, allows detecting very weak
echoes.
This is a function to sound an alarm when the specified
time has elapsed. When you click the left button on the
[WATCH] box, the counting is reset. The counting is also
reset when you click [ALARM ACK] box or press
[ALARM ACK] key.
Adjusts the sound level of alarms outputted from the
Control unit. Alarms are also outputted from the remote
Control unit.
Outputs alarm signals to external equipment when
selected alarms such as Guard Zoon ALARM,
SYSTEM ERROR and/or etc. Contact signals are
outputted at the EXT ALM terminals, ALM-1, 2, 3, 4 on
the TB board. Normal Open and Close can also be set.
See Chapter 4 for details.
Setting for ON/OFF of ANCHOR WATCH and the range
of watching,.
NOTE: Not displayed when it is IMO and A TYPE in the
[Menu] -> 0 -> 4 -> 7:TYPE.
Sets whether to fix the Guard Zone by the true bearing (T)
or relative bearing (R.)
Guard Zone No.1 allows the setting of a Guard Zone and
Guard Zone No.2 the setting of a polygon. The setting of
Guard Zone No.2 is enabled only when Guard Zone No.1
has been set.
Allows the setting of Trial Maneuver to avoid collision.
Specify the DYNAMIC or STATIC mode and enter the
trial speed rate and trial turn rate corresponding to two ship
speeds. When the [TRIAL] box is active, COG and SOG
entry boxes are displayed. Enter appropriate values in
respective boxes. Simulation is performed on the basis of
entered data, trial speed rate and trial turn rate. "T" is
displayed during simulation and cleared in 3 minutes. The
entered data is also used for the calculation in [Menu] -> 8
-> 0 -> 3:TURNING LINE.
Allows the setting of symbol color, size, past position color
and past position points of the ARPA.
Allows the setting of symbol color, size, past position
color, past position points and ROT TAG LIMIT of the
AIS.
If two target symbols of AIS and ARPA are displayed, the
targets are not clearly viewed. To avoid this, AIS targets
alone are presented if AIS and ARPA targets meet
conditions set in this menu in terms of the range, bearing
etc.
3-27
3.3 Main Menu Tree