Furuno FAR-2107 Series Service Manual page 89

The current software can be installed onto SPU boards –33 and before.
(1) A target echo is displayed with more smoothed edge. A closed target is more
easily identified on a short range. (Related software: ECHO FPGA)
(2) ARPA target swap to sea clutter is improved. (Related software: SPU FPGA)
(3) TTM data is always output from ECDIS port, J619 on TB board, regardless of
INS menu setting. (Related software: MAIN)
INS menu setting
(MENU > 0 > 8 > 5)
OFF
SERIAL
LAN
(4) Wind direction reference is selected according to the display mode as below.
(Related software: MAIN)
HU, HU-TB, and CU: Referenced to ship's bow
NU and TM: Referenced to North
(5) The maximum vector length is changed from 30 minutes to 60 minutes and any
value is selectable in the range from 1 minute to 60 minutes by using mouse
wheel. Left-clicking the mouse button sequences through all of the vector
lengths: 30 sec, 1 to 15, 20, 30, 40, 50, and 60 minutes. (Related software:
MAIN)
Previous software: 30 sec, 1, 2, 6, 12, 15, and 30 minutes
Current software: 30 sec, 1 to 60 minutes
(6) SPU program on the SPU board -44 is updated through the LAN port. Supplied
are two bat files: one for serial port and the other for LAN port. (Related software:
BOOT)
Note:
(1) RFC program cannot be updated through the LAN port.
(2) To use the LAN port on SPU boards –33 and before for software update,
SPU program is updated to V02.43 with the mini program card.
Program Name
ARPA CPU
DRAW CPU
MAIN CPU
FPGA
C-MAP MAIN CPU
J619
ECDIS TRACK CONTROL
Yes No
Yes (No) Yes
Yes No
Bat file for Serial port
Uparpa.bat
Updraw.bat
Upmain.bat
Upfpga.bat
N/A
Output ports
J620
No
No
Yes
( ): Previous software
Bat file for LAN port
setuparpa.bat
setupdraw.bat
setupmain.bat
setupfpga.bat
setupmainc.bat
2/3
LAN