Furuno FAR-2107 Series Service Manual page 240

[CARD1/2]
1 BACK
2 DRIVE SELECT
3 [READ CARD]
4 [WR MARK]
5 [WR NAV LINE WPT]
6 [WR OWN TRACK]
7 [WR TARGET TRACK]
6 CARD
8 [WR SETTING DATA]
9 [WR INSTALLATION DATA]
0 NEXT)
[CARD2/2]
1 BACK
2 [FILE DELETE]
3 [CARD INITIALIZE]
1 BACK
2 DEPT
3 DEPTH GRAPH SCALE
4 DEPTH MARK
5 CURRENT
6 WIND
7 TEMP
7 NAV DATA
8 DATE-TIME
9 LOCAL TIME ADJ
0 WPT DATA
Selects the RAM card slot of CU-200.
"A" is for the left slot and "B" for the right slot. When the
2nd CU-200 is added, the drives "C" and "D" are added.
Reads data from the RAM card. During reading the data, a
message "WORKING IN PROGRESS" is displayed in
Alert box in the lower right screen.
Each selected data is written on the RAM card.
Mxxxxxxx: WR MARK
Wxxxxxxx: WR NAV LINE WPT
Txxxxxxx: WR OWN TRACK
Axxxxxxx: WR TARGET TRACK
Sxxxxxxx: WR SETTING DATA
Ixxxxxxx: WR INSTALLATION DATA
Note:
Writing operation can be checked by the message "WR
CARD DATA" in the Alert box in the lower right screen.
Deletes a selected file stored on the RAM card.
Initializes the RAM card.
Allows displaying the following data in the data box. To
display them, turn on the setting in [Menu] -> 9 -> 2 -> 3:
NAV DATA.
- DEPTH: DPT>DBT>DBS
- CURRENT: VDR
- WIND: MWV>VWT>VWR
- TEMP: MTW
- DATE & TIME: ZDA
- WPT DATA: Selects whether to display the WPT in
the relative bearing or true bearing.
Note:
To display the NAV data, turn on the setting in [Menu] ->
9 -> 2 -> 3:NAV DATA.
3-30
3.3 Main Menu Tree