Furuno FAR-2107 Series Service Manual page 436

TB board (03P9342) connector No.
J618 (8P-NH)
J619 (3P-WAGO)
J620 (5P-WAGO)
J621 (6P-WAGO)
J622 (2P-XH)
Connector for Video, HD, B.P and Trigger output signals from
SUB DISPLAY-2
master radar. Video signal is in SEMI-LOG.
TTM output of IEC61162-1 type. For outputting TTM, set
ECDIS [Menu] -> 0 -> 6 -> 2:TTM OUTPUT to REL/TRUE and
[Menu] -> 0 -> 8 -> 5:Other to OFF
Connector to INS. Set [Menu] -> 0-> 8 -> 5 to Serial.
IEC61162-1 and 2 type. Supports the TX and RX data speed
between 4800 bps to 38.4 kbps according to input data speed
and automatically switched.
TRACK
CONTROL
NOTE: In the program of SPU Ver.50.08 and after;
It is for RX port of GPS buoy sentence, and the sentence of
NAV, ECDIS cannot receive.
RX sentence: $GBBLV, &XXGLL, $TLL
SERIAL I/F Unassinged
KEY Connected in parallel like EXT ALM Ack of J612 (EXT. ALM)
Table 7.3.1(2/2) Connector on the TB board
Overview
7-31
7.3 Processor Unit (RPU-013)