Pre Dcombiner - Safran RX-1 User Manual

7.2 Pre D combiner
The pre D combiner is used to:

Put the two channels in phase

Sum the two signals under weighting

Compensate high rate fading
Pre D combiner block diagram:
The Numerically Controlled Oscillators n°1 and n°2 put the two channels in phase.
The sum is weighted using the parameters α1 and α2.
Pre D combiner setting:

Selecting "Optimum", the pre-D combiner schematics is as described on the above schematics.

Selecting "Best", the pre-D combiner output selects the signal with the highest level

Selecting "Optimum criterion", the combiner stops combining as soon as it does not improve the signal.
Adapted to Frequency diversity and for a maximum bitrate of 1Mbps.
© Safran Data Systems – IMP000074 e14r1
RX-1 Compact Operational Receiver
User's Manual
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Ref. D104047
Is.Rev 08
Previous Ref.: -
Date: 21/06/2021
Safran Data Systems
.
Page 98