C-DOT DSS MAX-XL Installation Manual page 372

Appendix - I
Warning
6. If it is a Digital BM (i.e., all TUs are DTUs), unequip TTC by uneq-srv-card
command.
7. Repeat steps 3 to 7 to equip all other BMs.
8. Invoke crp and (exec.cmd file : amlpr.cmd;
9. Shut down and Boot the IOP-0 after all BMs are equipped.
10. Bring IOP-1 to warmstart level if it is inservice.
11. Bring IOP-0 to INS level by giving command INIT-IOP:5,1;
12. Give part-init to the system.
Now that the BM equipping part is over, the actual exchange data generation
can be done.
PROCEDURE TO BE FOLLOWED FOR PREPARATION OF DATA :
13. Invoke crp (Refer note 1 below for information about the following command
files).
crp
Create the command files through CRE-CMD-FILE command Execute them
one by one using the commands given below in the order given.
*
!
372
: After each step come out of crp and check the log.
(exec-cmd-file:fil-nam=aefrm.cmd,break=y;
(exec-cmd-file:fil-nam=aetrm.cmd,break=y;
(exec-cmd-file:fil-nam=aemfc.cmd,break=y;
(exec-cmd-file:fil-nam=aesrv.cmd,break=y;
(exec-cmd-file:fil-nam=amxcd.cmd,break=y;
(exec-cmd-file:fil-nam=amans.cmd,break=y;
(exec-cmd-file:fil-nam=actgp.cmd,break=y;
(exec-cmd-file:fil-nam=acsub.cmd,break=y;
(exec-cmd-file:fil-nam=acrut.cmd,break=y;
(exec-cmd-file:fil-nam=achgp.cmd,break=y;
(exec-cmd-file:fil-nam=amdty.cmd,break=y;
C-DOT DSS MAX-XL