15.1. INTRODUCTION
This chapter gives details on settings of different parameters of VDU and printer.
In case VDU or printer is not functioning properly, check for these
parameters/switch setting before attempting any repair.
15.2. VDU SETTING
Switch `ON' the VDU terminal and enter setup mode by pressing `F3'. There are
seven different set-ups listed below :
i)
Display Set-up
ii)
Special Set-up
iii)
General Set-up
iv)
Communication Set-up
v)
Printer Set-up
vi)
Keyboard Set-up
vii)
Tab Set-up
Parameters for each set-up are listed below. These are specifically for a VXL VM-
2620 terminal.
i)
Display Set-up
80 columns
Interpret controls
Auto wrap
Jump scroll
Light text, Dark screen
Intensity = 10
323
C-DOT DSS MAX-XL
Chapter 15.
VDU & Printer Setting