Jumper Settings In Iop - C-DOT DSS MAX-XL Installation Manual

16.4.8. APC-SCU363/H-M02 (Mother Board of 5th Frame Copy 1 side)
Jumpers W13, W16, W17, W19, W21, W22,W23,W24 are to be shorted.
For jumpers W23 & W24 refer Figure 16.1.
16.4.9. APC-HPU395/H-M00 (Mother Board of 6th Frame Copy 0 side)
Jumpers W1, W2, W3, W6, W8, W10 are to be shorted.
16.4.10. APC-HPU396/H-M00 (Mother Board of 6th Frame Copy 1 side)
Jumpers W14, W16, W18, W19, W20 are to be shorted.
For Jumpers W19 and W20 refer Figure 16.2
16.4.11. APC-ESM397/H-S01
2 PIN JUMPERS (In all slots)
Jumpers W11, W21, W22, W24 are to be shorted. Rest of the Jumpers are to
be left open.

16.5. JUMPER SETTINGS IN IOP

16.5.1. APC-VHC358/O-S00
Jumpers W13, W14, W15, W17, W18 are to be shorted. Rest of the jumpers
are to be kept open.
16.5.2. APC-VHI359/F-S00
16.5.3. Jumper Settings in Hard Disk
1.
16.5.4. Jumper Settings of Cartridge Tape Drive
a)
b)
INSTALLATION MANUAL
Quantum - Model TM 1280S (1.2 GB)
A0 - Open
A1 - Open
A2 - Short
Rest of the Jumpers should not be disturbed.
150 MB (5150 ES) of Wangtek Corporation, USA Refer Fig. 16.3.
Jumpers E5, E2, E1 to be shorted.
In J10 2nd pin (column) should be shorted and remaining are all open.
Jumper E20 and J32 are open.
TDC 3660 Tape Drive of Tandberg
No jumper settings.
JUMPER SETTINGS
341