Table of Contents
Advertisement
16.1. INTRODUCTION
This document describes the types of jumpers used in MAX-XL cards and the
position of required shorts.
16.2. DESCRIPTION OF JUMPER TYPES
There are three types of jumper settings in MAX-XL cards. They are described
individually with an example.
2 Pin Jumpers (2P)
In this type of jumper settings, there are only 2 pins and the instruction required is
whether the jumper position needs to be shorted or not to be shorted.
Example :
In APC-MSC014/F-S07, W1 and W4 are two pin Jumpers
W1
W4
3 Pin Jumpers (3P)
In this type of jumper settings, there are 3 pins and the instruction required is
whether the jumper position needs to be shorted or not. If shorting is needed further
instruction should be which 2 pins (out of the total 3 pins) are required to be
shorted.
Example :
In APC-TGA077/T-S02 W1 and W2 are 3 pin jumpers.
W1
W2
INSTALLATION MANUAL
Chapter 16.
Jumper Settings
-
To be shorted
-
Not to be shorted
-
Has to be shorted for position `bc'
-
Has to be shorted for position `bc'.
328
Advertisement
Table of Contents
