Table of Contents
Advertisement
Chapter 10.
10.3. CABLE PREPARATION
For the preparation of cables, all details required are made available in the
following standard format :
CDOT ASSY NO
DRAWING NO.
CABLE PART NO.
CABLE MARKER NO.
CABLE SPECIFICATION
CABLE UNIT COLOUR CODE
CABLE LENGTH
SOURCE TERMINATION PART NO.
DESTINATION TERMINATION PART
NO.
SOURCE PLACEMENT
DESTINATION PLACEMENT
ASSEMBLY PROCEDURE
The cables having common parameters are grouped together in Tabular form.
10.4. GROUND CABLES
Ground cables are laid from Earth collector plate to various equipments like
switching cubicle in Power room, MDF, DCDPs, IDP, antistatic flooring etc. This is
represented with the help of a block diagram in Fig. 10.1 (a). Similarly laying of
ground cables from DCDPs to Power distribution panels of all suites and from there
to individual cabinets is shown in Fig. 10.1 (b). However detail of each cable is given
below.
100
:
This is the number given to an assembled cable
with both source and destination termination
arrangements done.
:
This is the drawing number which can be
referred for the assembly of the cable.
:
This number gives the type of cable used.
:
This number is given to the cable which gives
an identity to the cable.
:
Self explanatory
:
Self explanatory
:
Self explanatory
:
This number gives the detail of the termination
arrangement used at the source point.
:
This number gives the detail of the termination
arrangement used at the terminating point.
:
This gives the place detail from where the cable
will start.
:
This gives the place detail where the cable will
be terminated.
:
This gives information about the tool to be used
for crimping of lugs etc., at source and
destination for assembling the cable.
C-DOT DSS MAX-XL
Advertisement
Table of Contents
