Chapter2 Instrument Introduction; Unpacking And Transportation - ITech IT7900P Series User Manual

Unpacking and Transportation

2.1
Unpacking
For cabinet products, they are packaged in wooden boxes at the factory. After
you receive them, please refer to the unpacking instructions provided with the
box for disassembly; for products packaged in cartons, please use appropriate
tools for unpacking.
It is recommended to keep the complete transport packaging for the lifetime of
the device for relocation or return to the manufacture for repair.
Transportation
If you need to transport non-cabinet products, you must pay attention to the fol-
lowing to ensure the safety of equipment and personnel.
⚫
⚫
⚫
⚫
After unpacking the cabinet product, if you need to move it to other places, you
must pay attention to the following matters to ensure the safety of equipment
and personnel.
⚫
⚫
⚫

Chapter2 Instrument Introduction

Before moving, make sure that the cabinet or stand where the
equipment will be placed has been fixed and meets the load-bear- ing
conditions to avoid tilting and collapsing, causing personnel to be
injured, and equipment broken.
Due to the weight of the product, transport by hand should be avoided
where possible. If unavoidable, carry it with two people and holding
the product shell and not external parts (such as han- dles, electrodes,
knobs, etc.).
When carrying, be prepared to bear the weight to avoid sprains or being
crushed by heavy objects.
Use suitable safety clothing, especially safety shoes, when carrying the
equipment, as due to its weight a fall can have serious consequences.
The cabinet product is very heavy. Before moving to another loca- tion,
confirm whether the ground load is in compliance.
During the process of moving the cabinet, it is recommended that two
or more people cooperate and push it slowly and at a constant speed.
If you encounter a pit, you need to pay special attention. It is forbidden
to push it quickly, otherwise it will easily cause excessive inertia and
cause the casters at the bottom of the cabinet to jam and the cabinet
to fall.
It is not advisable to push down the slope to prevent the cabinet from
falling down due to the shift of the center of gravity. It is rec- ommended
Copyright ©ITECH Electronic Co., Ltd.
Instrument Introduction
17