ITech IT7900P Series User Manual page 92

Set the voltage and frequency parameters in the sweep interface.
7.
Parameters in the sweep interface are described as follows:
Parameter
Const mode
End
Start Level
Stop Level
Step Level
Mode
Step time
Repeat count
Waveform
Copyright ©ITECH Electronic Co., Ltd.
Explain
Sweep mode
CC and CR
Set the running state after the sweep
execution is finished:
• off: Directly off the input after the
execution is finished;
• Last: Keep the last waveform unchanged
after the execution is finished.
Normal: return to normal mode after the
sweep execution is finished.
Set the starting value.
Set the ending value.
Set the step value.
Set the sweep mode.
Time: Time Sweep Mode
Trig: Trigger mode
Time-back-forth: Step switching according
to time and scanning back and forth.
Trigger-back-forth:
according to trigger and scanning back and
forth.
Set the step time.
Repeat count
Select sweep waveform
Sine
Square
Sawtooth
Triangle
Trapezoid
Operation and Application
Step switching
90