One-Arm Wheel Lock - Physipro XL 5 Owner's Manual

ENGLISH ENGLISH

One-Arm Wheel Lock

The one-arm wheel lock allows the occupant to engage both wheel locks
simultaneously with a single wheel lock handle installed on either the left or right
hand side. The one-arm wheel lock system can be installed in our factory if selected in
the order form.
Adjusting the brake force
If necessary, you can increase or decrease the brake force.
1. With a 1,5mm Allen key, slightly
loosen the set screw A.
2. Adjust the cable tension:
3. Pull the cable forward to increase
brake force.
4. Push the cable
decrease brake force.
5. Once the desired brake force is
obtained, tighten set screw A firmly.
Note-When engaged, the wheel lock pressure bar should embed ⅛'' to ¼'' into the tire.
Using wheel locks
Push-to-lock
- To lock wheels, push handle C
forward.
- To unlock wheels, pull handle C
backwards
Push-to-lock
WARNING
Never stop a moving wheelchair with wheel locks. Wheel locks are used to
lock the propulsion wheels and immobilize the wheelchair. Wheel locks are
not designed to slow down or stop a moving wheelchair.
backwards to
64
XL5 and XL RF
Pull-to-lock
- To lock wheels, pull handle C
backwards.
- To unlock wheels, push
handle C forward.
Pull-to-lock
ENGLISH
Cable