Physipro XL 5 Owner's Manual page 68

ENGLISH
3. Assemble axle and propulsion wheel with one handrim:
a. Place inner locking shaft coupling
I on axle J.
b. Insert axle J through wheel hub.
c. Fasten the outer locking shaft
coupling K on axle J with a 13mm
wrench while holding the axle
flats with another 13mm wrench.
d. Make sure there is not rotation
between propulsion wheel and
axle.
e. Secure the axle J by tightening
locknut L with a 13mm wrench.
4. Install propulsion wheel assemblies:
a. Insert the axle of the propulsion
wheel assembly M into the axle
retention
keeping the lever O engaged.
b. Release lever O and make sure
propulsion wheel assembly M
cannot be removed.
c. Repeat these steps for the
opposite side.
5. Install spring loaded shaft on axles:
a. Place spring loaded shaft P on
the end of an axle.
b. Compress
shaft and position the other end
on the opposite axle.
c. Make sure the spring-loaded
shaft is properly installed by
turning the small inner handrim
and checking that movement is
transmitted to the opposite
propulsion wheel.
N
device while
the spring-loaded
68
XL5 and XL RF