Xl5 - Physipro XL 5 Owner's Manual

Owner's Manual

XL5

TECHNICAL SHEET – USE AS A SEAT IN A MOTOR VEHICLE
Read this entire manual before using your wheelchair in an adapted vehicle. Be
sure to use the wheelchair tie-down and occupant restraint systems that meets
ISO/DIS 7176-19:2019 standards or risk serious physical injury or death.
If you have any questions regarding the use of this wheelchair as a seat in adapted
transport, contact Physipro Inc. at the following number: 1 800 668-2252.
INTRODUCTION
The XL5 wheelchair complies with the ISO/DIS 7176-19:2019 standard and was
designed to be placed in a forward-facing position while used as a seat in a
motor vehicle.
Note: Compliance with this standard does prohibit using the wheelchair in a
rear-facing position in larger adapted vehicles, that are equipped with rear-
facing wheelchair passenger stations.
The XL5 wheelchair is equipped with belt restraint devices in accordance with
the requirements of the ISO/DIS 7176-19:2019 standard and has successfully
passed a frontal impact crash test with a 76.3 kg (170 lbs) dummy.
The XL5 wheelchair is equipped
with factory-installed securement
points and uses a four-point strap
tie-down restraint system.
Only use wheelchair tie-
down
restraint
meet the ISO/DIS 7176-
19:2019 standard, failure to
do so may lead to serious or
even fatal injury.
73
ENGLISH
and occupant
systems which
Revision 0
July 2022