Attendant Wheel Lock (4-Wheel Or 6-Wheel Option); Installing The Attendant Wheel Lock; Adjusting The Brake Force; Using The Attendant Wheel Lock - Physipro NeoX DYNAMIC Owner's Manual

ENGLISH

Attendant Wheel Lock (4-wheel or 6-wheel option)

Installing the attendant wheel lock

Insert parts A and B into tube
1.
C and adjust the width of the
attendant
according to the width of the
wheelchair.
2. Position and adjust bracket
on the side frame rails.
3. With two 13mm wrenches,
tighten bolts F firmly.
Center tube C and then firmly
4.
tighten screws D with a 10 mm
wrench.

Adjusting the brake force

1. With two 13mm wrenches, remove bolts F.
2. Move the attendant wheel lock brackets forward or backwards to obtain the
required brake force.
- To increase brake force, move attendant wheel lock backwards closer to
the propulsion wheel.
- To reduce brake force, move wheel lock further from propulsion wheel.
3. Reinsert bolts F and firmly tighten.
Note – Make sure the wheel lock pressure bar G is placed at approximately ½"
from the propulsion wheel, when disengaged.

Using the attendant wheel lock

-
To lock wheels, push down
on side H of the foot
operated lever.
-
To unlock wheels, push
down on side I of the foot
operated lever.
wheel lock
E
NEOX TM
64
Dynamic wheelchair