L'' Type Armrest (Xl Rf Only) - Physipro XL 5 Owner's Manual

ENGLISH

''L'' Type Armrest (XL RF only)

The ''L'' type armrest is made with a foam padding to improve comfort and can be
flipped back to facilitate transfers.
The ''L'' type armrest offers a height adjustment range between 8'' and 14'' (200 mm
and 330 mm). Adjustable in increments of ½''.
Installing the ''L'' type armrest
1. Remove cap at the end of seat rail.
2. Insert the connector tip A at the
end of seat rail.
3. Insert alignment sleeve and secure
connector to the seat rail by
fastening bolt B with two 10mm
wrenches.
Adjusting the ''L'' type armrest height
1. With a 10mm wrench, remove screw
C.
2. Raise or lower armrest.
3. Insert screw C in the appropriate
height adjustment hole.
4. Tighten screw C firmly.
Flipping back the ''L'' type armrest
1. Flip back armrest.
Installing the clothing guard
1. Position clothing guard on seat rail.
2. With a 4mm Allen key, fasten bolts D.
WARNING
Always check that armrests are well adjusted and locked in place.
•
Never lift the wheelchair by the armrest. Damage or injury may occur.
•
Always use the rigid parts of the frame when lifting the wheelchair Never
•
lift yourself up by pushing down on the ''L'' type armrest. (push-up).
Improper use may result in injury to the occupant or wheelchair damage.
•
58
XL5 and XL RF