Modifying The Position Of The Axle Mounting Plate; Front Seat-To-Floor Height; Modifying The Position Of The Caster Wheel - Physipro XL 5 Owner's Manual

ENGLISH

Modifying the position of the axle mounting plate

1. Remove propulsion
referring to
propulsion wheels - Threaded axle or
Removing propulsion wheels - Quick-
Release axle, depending on the type of
axle installed.
2. With two 10mm wrenches, unfasten
screws A.
3. Position the axle mounting plate and
insert screws A into the appropriate
adjustment holes to obtain the
desired seat -to-floor height.
4. Tighten screws A firmly.
5. Reinstall propulsion wheel.

Front seat-to-floor height

Modifying the position of the caster wheel

1. With two 13 mm wrenches, unfasten
bolt B and remove spacers if
necessary.
2. Refer to the Front Seat-to-Floor Height
Configuration Table of your frame
type to determine the correct caster
wheel position to obtain the desired
front seat-to-floor height.
3. Position the caster wheel and insert
bolt B with
appropriate adjustment hole.
4. Tighten bolt B firmly.
Note - Make sure the wheel rotates easily
once the bolt has been installed.
wheels by
section Removing
spacers into the
38
XL5 and XL RF