Using The Quick-Release Axle; Removing Propulsion Wheels - Quick-Release Axle - Physipro XL 5 Owner's Manual

Owner's Manual
WARNING
Keep quick-release axles clean and free of dust or lint to ensure its proper
•
operation. Lubricate if necessary.
Always make sure the wheels are securely locked before using your
•
wheelchair, an unlocked wheel may detach during use if not properly
secured and can result in a fall.

Using the Quick-Release axle

Available as an option with the XL5 and XL RF wheelchairs, the Quick-Release Axle
can be installed to facilitate the removal and installation of the propulsion wheels.
Removal of the wheels can be done in three easy steps.
1. Disengage wheel locks. Depending on the
type of wheel lock installed, either push or
pull the handle to disengage wheel locks.
2. Press down on the quick-release button D at
the center of the wheel.
3. Hold button D down and remove the wheel
by pulling outwards.
To reinsert wheel, hold button D down and reinsert axle.
Note - Make sure retaining balls project completely out from the axle bushing and
the tip of the ball lock pin is aligned with the tip of the axle before using your
wheelchair.
Removing propulsion wheels – Quick-Release axle
1. With a 1⅛" wrench, unfasten nut
I and remove lock washer H and
lock washer G.
2. With a 1⅛" wrench, unfasten nut
C and remove lock washer D.
Remove axle A from axle bushing
3.
E and wheel hub B.
43
ENGLISH
Revision 0
July 2022