ENGLISH
Modifying the standard backrest angle
The angle of the backrest can be adjusted
to accommodate the needs of the
occupant.
1. With a 4mm Allen key and a 10mm wrench,
remove bolts B.
2. Once the bolts are removed, reposition the
back post at the desired angle.
3. Reinsert bolts B in the adjustment holes
corresponding to the desired angle and
tighten firmly.
-
Note
The interval between two consecutive adjustment holes is 5⁰. For a 120⁰
backrest angle, use the 115⁰ position in combination with the upper 120⁰
adjustment hole. The 120⁰ backrest angle is achievable with standard back post
only.
Installing the dynamic backrest
The Standard backrest can be replaced by a Dynamic backrest to better
accommodate the occupants needs, by following these steps.
1. Remove armrests and propulsion wheels.
2. Remove backrest, tension bar and stroller bar, if
applicable.
3. With a 10mm wrench, remove screw A and lock
washer and pull out the upper back post.
4. With a 4mm Allen key and a 10mm wrench,
unfasten bolts B and remove the lower back
post.
5. With a 4mm Allen key and a 10mm wrench,
unfasten bolts C to remove the positioning
plates.
Note - If positioning plates cannot be
dislodged easily, remove the alignment
sleeves, located in the seat rail, with a flat
punch, this will facilitate the removal of the
positioning plates. Reinsert the alignment
sleeves in the seat rail before installing
dynamic positioning plates.
52
XL5 and XL RF