Installing Propulsion Wheels - Quick-Release Axle; Adjusting The Quick-Release Axle - Physipro XL 5 Owner's Manual

ENGLISH
Installing propulsion wheels – Quick-Release axle
1. Make sure the mounting plate F is
properly positioned and securely
fastened, if not, please refer to
section Modifying the position of
the axle mounting plate.
2. Insert the axle bushing E into the
mounting plate F in the desired
position and place the lock
washer G on axle bushing E.
3. With a 1⅛" wrench, secure the
axle bushing E in place with lock
washers D and H and nuts C and I.
4. Insert axle A through wheel hub B
and axle bushing E.
Note - Before using your wheelchair, it is important to adjust the Quick-release axle.

Adjusting the Quick-Release axle

Adjusting the quick-release axle is necessary if the propulsion wheels do not rotate
easily or if irregular movement is observed.
To adjust the quick-release axle, tighten or loosen nut C with a 3/4" wrench while
holding the tip of the axle in place with a 7/16" wrench. Make sure retaining balls A
project completely out from the axle bushing B.
WARNING
After all adjustments or reinstallation of the propulsion wheels, always
•
make sure the retaining balls of the quick release axle project completely
out from the axle bushing and that the tip of the ball lock pin is perfectly
aligned with the tip of the axle before using your wheelchair.
42
XL5 and XL RF