Quick Release Axle; Horizontal Adjustment - Physipro NEOX Tilt-in-Space Owner's Manual

ENGLISH
6.3 Quick release axle (Optional)
Follow these steps to uninstall quick release:
1. Release the wheel lock by pulling it backward;
Completely depress quick-release button A;
2.
Remove the wheel while keeping the button A pushed in.
3.
When you re-install the quick release axle, ensure that both quick-release
rear axles are locked. An unlocked axle may come off during use and
cause a fall.
6.4 Adjusting the Wheelbase forward and back
The mid wheel drives' position is very
important for the base stability. The more the
mid wheel drives are positioned forward, the
more the stability is decreased. However, it
facilitates propelling. To satisfy the need of
each individual it is possible to proceed to
different horizontal adjustments.
Follow these steps:
1. Remove the rear wheel (refer to section 7);
2. Unscrew screw A and B using 13 mm Allen
Key;
3. Slip the anchoring plate to obtain the
desired position;
4. Replace screw A and B, tighten.
Always use the more stable position (Wheel Backward) to guaranty
stability. To propel, consider the 6 wheel configuration.
Figure 13 : Quick Release Use
16
NEOX™ Tilt-in-Space
Insert fully lock
pin
A
Figure 14 : Adjusting the Wheelbase forward
and back
B