Installing Rear Wheels - Quick-Release Axle; Adjusting Quick Release Axle - Physipro XL5 Owner's Manual

Owners manual

6.2 Installing Rear Wheels - Quick-Release Axle

Make sure the positioning device E is inserted in plate F including locking
1.
device G;
Secure it firmly in place with the lock washer D and H and nut C and I ;
2.
Insert axle A in the positioning device E with the wheel hub B.
3.

6.3 Adjusting Quick Release Axle

The balk A must exceed the positioning device B and be completely output to hold
the wheel assembly. Tighten or loosen nut C with a 3/4" wrench and a 7/16" wrench.
Make sure the detent pin and detent balls of the quick release axle are
fully release before operating the wheelchair. The detent balls MUST be
protruding past the inside of the rear wheel axle bushing for a positive
lock.
Check that quick-release axles lock properly. Lubricate if necessary.
Keep quick-release axles free of dirt and lint to ensure positive locking and
proper operation.
Figure 15 : Installing Rear Wheels - Quick-Release Axle
19
ENGLISH
Revision 5
December 2015