Installing Propulsion Wheels - Quick-Release Axle; Removing Propulsion Wheels -Quick-Release Axle; Adjusting The Quick-Release Axle - Physipro NeoX DYNAMIC Owner's Manual

ENGLISH
Installing propulsion wheels – Quick-Release axle
sure the mounting block F
1. Make
is properly positioned, if not,
please refer to section Modifying
the position of the axle mounting
block.
2. Insert the axle bushing E in the
desired height-adjustment hole
of mounting block F.
3. With a 1⅛" wrench, secure the
axle bushing E in place with lock
washers D and nut C.
4. Insert axle A through wheel hub
B and axle bushing E.

Removing propulsion wheels -Quick-Release axle

1. Unfasten nut C and remove lock washers D.
2. Slide axle A out of wheel hub B and axle bushing E.

Adjusting the Quick-Release axle

Adjusting the quick-release axle is necessary if the propulsion wheels do not rotate
easily or if irregular movement is observed. To adjust the quick-release axle, tighten or
loosen nut C with a 3/4" wrench while holding the tip of the axle in place with a 7/16"
wrench. Make sure retaining balls A project completely out from the axle bushing B.
Quick-Release axle adjustments
32
NEOX M Dynamic wheelchair
T