Table of Contents
Advertisement
Owner's Manual
Note - Depending on the selected size of the propulsion wheels, the seat-to-floor height
may be limited to 13", 14" or 15".
Propulsion Wheel
Diameter
20" (510 mm)
22" (560 mm)
24" (610 mm)
Note - The desired seat-to-floor height of the 6-Wheel Neox Dynamic wheelchair will
be determined by the size of the propulsion wheels only. The caster wheels are
supplied and pre-assembled to dynamic forks with a diameter of 5" (127 mm) or 6"
(152 mm).
Modifying the position of the axle mounting block
1. Remove propulsion wheels by referring to
section Removing propulsion wheels -
Threaded axle or Removing propulsion
wheels - Quick-Release axle, depending on
the type of axle installed
2. Unfasten nuts A with a 13 mm wrench
and remove bolts B.
3. Determine if mounting block C should be
placed upward or downward on the side
frame rail to obtain the desired seat-to-
floor height. Move the mounting block C
forward or backward to the desired
location.
4. Reinsert bolts B and tighten nuts A.
5. Reinstall propulsion wheel at the desired
position (see Configuration Tables).
6-Wheel Configuration Table
Seat-to-Floor
Height
13" to 17"
(330 to 430 mm)
14" to 18"
(360 to 460 mm)
15" to 19"
(380 to 480 mm)
29
Required Position
P1
X
X
X
ENGLISH
P2
Revision 0
July 2022
Advertisement
Table of Contents
