Arming In Away Mode; Disarming From Away Mode; Arming In Stay Mode 1; Disarming From Stay Mode 1 - Bosch ICP-CC408 Installation Manual

ICP-CC408 | Installation Guide | 5.0
Figure 5: RE012/E: 2-Channel Keyfob
Transmitter
1
3
1 – Button 1: Arm or disarm in AWAY Mode
2 – Button 2: Arm or disarm STAY Mode
3 – Buttons 1 and 2: Press both buttons at same
time to activate Panic alarm.
5.4.1

Arming in AWAY Mode

Press and hold the black button for 2 sec.
Two beeps sound on the remote codepad and the
AWAY indicator lights. Exit Time starts.
If horn speaker indication beeps are enabled, two
beeps sound from the horn speaker. If strobe
indications are enabled, the strobe flashes for 6 sec to
indicate the system is armed.
5.4.2

Disarming from AWAY Mode

Press and hold either the black or green button for 2
sec.
Two beeps sound on the remote codepad and the
AWAY indicator is extinguished.
If horn speaker indication beeps are enabled, one
beep sounds from the horn speaker. If strobe
indications are enabled, the strobe flashes for 3 sec to
indicate the system is disarmed.
5.4.3

Arming in STAY Mode 1

Press and hold the green button for 2 sec.
Two beeps sound on the remote codepad and the
STAY indicator lights. Exit Time starts.
If horn speaker indication beeps are enabled, one
two-tone beep sounds from the horn speaker. If
strobe indications are enabled, the strobe flashes for
6 sec to indicate the system is armed.
5.4.4

Disarming from STAY Mode 1

Press and hold either the black or green button for 2
sec.
Two beeps sound on the remote codepad and the
STAY indicator is extinguished.
If horn speaker indication beeps are enabled, one
beep sounds from the horn speaker. If strobe
indications are enabled, the strobe flashes for 3 sec to
indicate the system is disarmed.
Bosch Security Systems, Inc. | 12/08 | F01U089463-02
Remote Radio Transmitter Operations
5.4.5

Panic Alarm

Press and hold the black and green buttons together
for 2 sec.
An audible Panic Alarm is initiated that activates the
2
horn speaker, strobe, and internal sirens.
If Option 1 is selected in Location 425
(refer to Section 18.2 System Options 2
on page 79), the remote radio Panic
Alarm is also silent.
5.5 4-Channel Remote Radio Hand-
Held Transmitter Operations
Because all operations using the 4-channel remote
radio hand-held transmitter are fixed after the control
panel learns the hand held transmitter's code, no
programming is required for the transmitter buttons.
You can use the DOOR and AUX buttons on the
transmitter to operate the control panel's
programmable outputs (garage door or outside lights,
for example).
Figure 6:
1 – Button 1: Arm or disarm in AWAY Mode
2 – Button 2: Arm or disarm in STAY Mode
3 – Buttons 1 and 2: Press both buttons at same
time to activate Panic alarm.
4 – Buttons 3 and 4: Your security company can
program these buttons for optional operation,
such as operating a garage door.
5.5.1 Arming in AWAY Mode
Press and hold [AWAY] for 2 sec.
Two beeps sound on the remote codepad and the
AWAY indicator lights. Exit Time starts.
If horn speaker indication beeps are enabled, two
beeps sound from the horn speaker. If strobe
indications are enabled, the strobe flashes for 6 sec to
indicate the system is armed.
RE013/E: 4-Channel Keyfob
Transmitter
1
3
2
4
EN | 27