Two-Channel Remote Radio Hand-Held Transmitter Operations; Arming In Away Mode; Disarming From Away Mode; Arming In Stay Mode 1 - Bosch ICP-CC404 Installation Manual

To add or change a remote radio User Code:
1. Enter the Master Code and press [1][AWAY].
Three beeps sound and the STAY and AWAY
indicators flash.
2. Enter the user number (9 to 16) you want to add
or change and press [AWAY].
Two beeps sound and the corresponding zone
indicators light. Refer to Table 17.
Table 17: Codepad Indicators for Remote
Radio User Numbers
Data Zone Indicators
Value 1 2 3 4
9 X
10
11 X
12 X
13 X
14 X
15
16
3. Press any of the [TRANSMIT] buttons on the
hand-held transmitter to allow the control panel
to learn transmitter's ID code.
Two beeps sound and the STAY and AWAY
indicators turn off.
4. Repeat Steps 1 through 3 to add or change
another remote radio User Code.
This function ends automatically if you do
not press a button within 60 sec or if you
press [AWAY].
One long beep indicates that the code
already exists or you selected an
incorrect user number.
To delete a remote radio User Code:
1. Enter the Master Code and press [1][AWAY].
Three beeps sound and the STAY and AWAY
indicators flash.
2. Enter the user number (9 to 16) you want to
delete and press [AWAY].
Two beeps sound and the corresponding zone
indicators light. Refer to Table 17.
3. Press [STAY] to delete the User Code.
Two beeps sound and the STAY and AWAY
indicators turn off.
4. Repeat Steps 1 through 3 to delete another remote
radio User Code.
Bosch Security Systems, Inc. | 12/08 | F01U089401-02
ICP-CC404 | Installation Guide | 5.0
5 6 7 8 MAINS
X
X
X
X
X
X
X X
X X
Remote Radio Transmitter Operations
This function ends automatically if you do
not press a button within 60 sec or if you
press [AWAY].
One long beep indicates that you
selected an incorrect user number.
5.4 Two-Channel Remote Radio Hand-
Held Transmitter Operations
Because all operations using the two-button remote
radio hand-held transmitter are fixed after the control
panel learns the transmitter's code, no programming
is required for the transmitter buttons.
Figure 4: RE012/E: 2-Channel Keyfob
Transmitter
1
3
1 – Button 1: Arm or disarm in AWAY Mode
2 – Button 2: Arm or disarm STAY Mode
3 – Buttons 1 and 2: Press both buttons at the
same time to activate Panic alarm.
5.4.1

Arming in AWAY Mode

Press and hold the black button for 2 sec.
Two beeps sound on the remote codepad and the
AWAY indicator lights. Exit Time starts.
If horn speaker indication beeps are enabled, two
beeps sound from the horn speaker. If strobe
indications are enabled, the strobe flashes for 6 sec to
indicate the system is armed.
5.4.2

Disarming from AWAY Mode

Press and hold either the black or green button for
2 sec.
Two beeps sound on the remote codepad and the
AWAY indicator turns off.
If horn speaker indication beeps are enabled, one
beep sounds from the horn speaker. If strobe
indications are enabled, the strobe flashes for 3 sec to
indicate the system is disarmed.
5.4.3

Arming in STAY Mode 1

Press and hold the green button for 2 sec.
Two beeps sound on the remote codepad and the
STAY indicator lights. Exit Time starts.
2
25