Install Mode; Accessing Install Mode; Adding And Removing Points And Cards; Adding And Removing Lists - Simplex 4010ES Operator's Manual

7 Install Mode

The Install Mode is a 4010ES feature that allows the user to minimize the amount of Troubles that occur when the system is being
installed or when it is undergoing extensive service.
Install Mode allows the technician to select device points and cards that might raise Troubles due to installation issues and place them in
"Install Mode". Install Mode will only raise one Trouble "INSTALL MODE ACTIVE", regardless of the number of items in it.
Install mode is available on Panels programmed with a revision 1.01 of the ES Programmer or later.
7.1

Accessing Install Mode

Install mode is accessed directly from the user interface.
To access Install Mode:
1. Power-up the panel
2. Log into the FACP at a level3 or higher.
Once logged in, you can move and remove points, cards, lists and groups to and from Install Mode.
7.2

Adding and Removing Points and Cards

Moving a point or a card to Install Mode:
Important: A Card in the Install Mode List no longer reports Card Faults. For example, a Power Supply in Install Mode does not report AC
Failures, Depleted/Missing Batteries, or Ground Faults.
Press on the button that represents the point type you want to add to Install Mode. For example, press on the 6 button to access
1.
IDNet points.
2. Enter the Name or Address of the item you want to add.
3. Press Enter
4. Once the Item appears on the display, press the More Info button.
5. Use the arrows to find and select "Add this Point/Card to Install Mode?".
6. Press Enter to confirm the selection and move the item to Install mode.
Removing a point or a card to Install Mode:
1. Press on the button that represents the point type you want to move to Install Mode.
2. Enter the Name or Address of the item you want to move.
3. Press Enter
Once the Item appears on the display, press the More Info button.
4.
5. Use the arrows to find and select "Remove Point/Card from Install Mode?".
6. Press Enter to confirm the selection and remove the point/card from Install Mode.
Depending upon the state of the point being removed (normal or alarm, respectively), one of the following screens is displayed:
or
Important: An Alarm could be reported after removing a List or a Card from the Install Mode List (without warning).
7.3

Adding and Removing Lists

Adding and Removing Lists from Install Mode:
Note: For information on making lists refer to the ES Panel Programmer's Manual (574-849).
1. Press on the 9 button to access the lists.
page 20
4010ES Fire Alarm Operator's Manual
579-969 Rev E