How Do I Get Warranty Service - Aston Martin DB 9 2010 Manual

• Controls for Deceleration
• Distributor Assembly
• Electronic Ignition System
• Electronic Engine Control Sensors and Switches
• Exhaust Gas Recirculation (EGR) Valve, Spacer, Plate and
Associated Parts
• Exhaust Heat Control Valve
• Exhaust Manifold and gasket
• Fuel Filler Cap and Neck Restrictor
• Fuel Injection System
• Fuel Injector Supply Manifold
• Fuel Tank
• Fuel Vapor Storage Canister, Liquid Separator and Associated
controls
• Ignition Coil or Control Module
• Intake Manifold
• Malfunction Indicator Lamp (MIL) System
• PCV System and Oil Filler Cap
• Engine Control Module
• Pulsed Secondary Air Injection Valve, Secondary Air Injection
pump and Associated Parts
• Spark Control Components
• Spark Plugs and Ignition Wires
• Throttle Air Control By-pass Valve
• Throttle Body Assembly
• TWC Air Control Valve
• Volume Air Flow Sensor

How Do I Get Warranty Service?

To get service under your emissions warranties, take your vehicle to
any Aston Martin Dealer as soon as possible after it has failed an EPA-
approved test or a California Smog Check inspection. Be sure to show
the dealer the document that says your vehicle has failed the test.
The Aston Martin will decide whether the repair is covered by the
warranty. If there is a question about coverage, the final decision
must be made by Aston Martin within 30 days after you bring in your
vehicle for repair (The decision will be made within a shorter time if
the law requires you to have the vehicle repaired more quickly in
order to avoid additional penalties). However, your Aston Martin
Dealer does not have to meet the deadline if you request a delay or
agree to a delay, or if the delay is caused by an event for which
neither Aston Martin nor your Aston Martin Dealer is responsible.
C.13