Automatic Locking Retractors - Aston Martin DB 9 2010 Manual

Rear Passenger Seats
2+2 Coupe Only
Tether anchor points are located behind the top of the rear seats.
Engage the attachment clip in the orientation shown and make sure
that the locking spring has fully closed to prevent accidental
disengagement of the Tether strap.
Always make sure that the Tether strap length is adjusted to remove
any slack.
2+2 Volante Only
The 2+2 Volante Tonneau lid and Deployable Rollbars do not allow
the installation of rear seat tether anchor points. Do not use a child
restraint system or a booster cushion requiring the use of a Tether
strap on the rear seats as they can not be correctly secured in the
vehicle. If you choose to use a child safety seat or a booster cushion
on the rear seats always use the Automatic Locking Retractor seat
belts.
3.24
[1] - Tether anchor point
[2] - Tether strap
[3] - Seat belt
[4] - Attachment clip

Automatic Locking Retractors

Warning: Always follow the child seat manufacturer's
instructions. Not following the child-seat manufacturer's
instructions when installing the child seat is dangerous.
Aston Martin does not recommend any child seats for this vehicle
which require the use of the vehicle seat belt (Refer to 'Child Seats',
page 3.21).
The Automatic Locking Retractor (ALR) system is designed to securely
hold child seats. The ALR system temporarily locks the seat belt that
is securing a child seat.
ALR Operation
Gently pull out the seat belt until fully extended. The ALR system will
only engage at the maximum extension point of the seat belt. Thread
the belt tongue through the child seat as instructed by the child seat
manufacturer. Engage the tongue into the belt buckle.