Master Lamp Switch - Aston Martin DB 9 2010 Manual

Master Lamp Switch

If Homesafe has been set to ON with the Master Lamp Switch
at position three (headlamps ON), the main beam will stay ON.
Make sure that the Master Lamp Switch is at position one before
exiting (Refer to 'Homesafe', page 2.11).
[1] - All external lamps OFF.
[2] - Side, side marker, rear and
licence plate lamps ON.
[3] - With the vehicle key at position
'II' in the Ignition Control, Headlamps
ON, in addition to the side, side
marker, rear and registration plate
lamps.
4.14
Lamps ON Warning
If the vehicle side lamps are ON, and the drivers door is opened after
the vehicle key has been removed from the Ignition Control, an
audible warning will sound for a period of five minutes. To stop the
audible warning set the lamps to OFF. The audible warning will also
stop when the driver's door is shut - the lamps will stay ON.
Day Time Running Lamps
(Canada Only)
The dipped beams and side lamps are permanently ON.
Headlamp Levelling
The weight of passengers and items placed in the trunk may change
the beam angle of the headlamps. To compensate for this the
headlamps are continuously monitored and automatically adjusted.
Instrument Brightness
During the daylight hours the level of
instrument brightness defaults to maximum
brightness and is not adjustable. During the
twilight and night time hours a Twilight
sensor (A (located in the Centre Stack))
automatically reduces the level of
brightness to a preset level.
If the Twilight sensor is covered the level of brightness will stay
low as if in night time mode.