Tire Sealant Kit - Aston Martin DB 9 2010 Manual

Tire Sealant Kit

Warning: Do not use the system to seal a tire that was
damaged while driving with insufficient air pressure (e.g. tire
cuts, cracks, bumps or similar damage). Do not use the system to
seal tires with sidewall damage. Only punctures in the tread area
of tires may be sealed.
Warning: Do not stand directly beside the tire while the
compressor is pumping. Watch the sidewall of the tire. If there
are any cracks, bumps or similar damage turn OFF the
compressor. The journey should not be continued. Contact your
nearest Aston Martin Dealer.
Warning: If a tire pressure of 26 psi (1.8 bar) cannot be
reached in 7 minutes then the tire can not be sealed. Do not
attempt to re-inflate the tire. Contact your nearest Aston Martin
Dealer.
11.24
Warning: If the pressure in the tire after driving for 2 mile (3
km) is below 19 psi (1.3 bar) the tire has not been effectively
sealed. The journey should not be continued. Contact your
nearest Aston Martin Dealer.
Warning: After a longer period of rest, the tire pressure
should be rechecked.
Location
[A] - Coupe
[B] - Volante
Operation
Remove the Tire Sealant Kit from it's location in the trunk. Follow the
instructions detailed on the lid.
Read the following instructions and warnings carefully before using
the Tire Sealant Kit. Compliance with these instructions is vital to
make sure of vehicle and user safety. Noncompliance with these
instructions means risking severe tire damage and hazardous vehicle
behavior which can lead to a road accident involving damage to
property or injury to persons.
• Make sure the vehicle is parked far enough from traffic so that
there is no danger from passing vehicles and so that you do not
disrupt the traffic. Warn other vehicles using the warning triangle
• The system should only be used between temperatures of – 40°F
and 158°F (– 40°C and 70°C)