Aston Martin DB 9 2010 Manual page 217

Oil level check:
1. Withdraw and wipe the dipstick clean, using a
lint free cloth.
2. Fully insert the dipstick
with the Min. and Max.
marking on the blade
upwards (facing towards
the engine). Withdraw
again.
Approximately two pints
(one liter) is required to bring
the level from Min. to Max.
3. The oil level should read
between the Min. & Max. marks.
4. If required remove the filler, top
up to the Max. mark with the
recommended engine oil.
5. Wait for approximately two
minutes for the oil to settle, then
check the level again. Add oil if
required. Do not overfill.
6. Replace the filler cap securely, replace the dipstick and press it
home.
Brake Fluid Level
Warning: Do not drive the vehicle if the brake fluid level is
below the minimum mark.
Make sure brake fluid does not contact the paint work during
the topping-up operation. Serious paint work damage can result.
If a spillage does occur, immediately flush any brake fluid from
the paint work with clean, fresh water and then wipe with a clean
damp cloth.
Wipe the reservoir cap clean before removing to
prevent ingress of contaminants.
The brake fluid level should read between the Min.
and Max. marks.
1. Remove the reservoir cap. Top up to the Max.
level.
2. Install the reservoir cap securely.
11.11