Fuses - Aston Martin DB 9 2010 Manual

4. Connect the '-ve' (black) cable between the '-ve' (black)
terminal of the donor battery and a good earth (-ve) point in the
recipient engine bay (i.e. alternator mounting bracket).
5. Start the donor vehicle engine and run at about 1500 - 2000
rpm
6. Start the engine of the recipient vehicle.
7. Once both vehicles are running remove the jump start cables
(first the '- ve' (black) cable from both vehicles and then the
'+ve' (red) cable from both vehicles).
Allow the recipient engine to run until the discharged battery is
sufficiently recharged (15 to 20 minutes) to start the engine
without assistance. Set to OFF and restart the recipient engine.
Take the vehicle on a long run to fully charge the battery.
Contact your Aston Martin Dealer to have the battery checked or
replaced.
Recharge time will depend on the initial 'state of health' of
discharged battery.
If this vehicle will not start consult your Aston Martin Dealer.

Fuses

The electrical system is protected by
fuses. If any lamps, accessories, or
controls don't work, inspect the
appropriate circuit protector.
If a fuse has blown, the inside element
will be melted. If the same fuse blows
Normal
again, avoid using that system and
consult your Aston Martin Dealer as
soon as possible.
Fusebox Location
[1] - Engine Bay fuse box (Passenger side).
[2] - Cabin fuse box (Front Passenger footwell).
[3] - Trunk fuse box (Left side of trunk).
Blown
11.33