2. Adjust the headlamp
aim by turning the
adjusters using a T-20
torx driver.
[1] - Vertical aim
[2] - Horizontal aim
11.42
3. Replace the access panel by snapping into place and installing
the retaining screw, and turning 90° clockwise.
Check the vertical beam angle by reversing the vehicle backwards 12
ft (3.6 m) and repeating the check procedure. The beam height
should have reduced by 1 in (25 mm).
Door Window Reset
If power to the electric windows has been interrupted for any reason,
they will fail to operate correctly until reset.
1. Sit in the driver's seat. Close both doors, insert the vehicle key
into the Ignition Control and move to position 'II' (ignition ON).
2. Press firmly and hold the window switch until the window is at
the maximum down position. Continue to hold the button for
five seconds then release.
3. Pull back and hold the window switch until the window is in the
maximum up position. Continue to hold the switch for a further
five seconds, then release.
4. The window is now reset. Repeat for the second window.