Teledyne SeaBat T Series Operator's Manual page 99

TROUBLESHOOTING
Message
Failed to set up DMA Card 0, ERROR =
Failed to set up DMA Card 1
Failed to unregister external trigger, ERROR
=
FATAL ERROR: PPS Timestamp error
Check 1 PPS input
FATAL: DMA Read size limitation reached.
FIRMWARE does not support External
Trigger. Pinging is OFF
Inbound memory initialization failed.
Incorrect ADMXRC board found, card_1
Internal 7k Center error
Internal error, 7kCenter NOT fully
operational.
SeaBat T-Series Subsea Operator's Manual
Version 7
Description
One or more of the processing cards
has failed to initialize or is non-
functional within the sonar processor.
The software could not access the
processing card device.
External Trigger Firmware cannot be
initialized or not supported.
The pulse is not being detected. Time
stamping will be done using system
time only. 1 millisecond accuracy not
possible.
A general error occurred while
transferring data to the software.
External Trigger Firmware cannot be
initialized or not supported.
PC resources are inadequate.
One or more of the processing cards
has failed to initialize or is non-
functional within the sonar processor.
One or more startup conditions have
failed.
One or more startup conditions have
failed.
Page 87
Action
Reboot sonar processor and try again.
Check ADMXRC drivers.
Reboot the system.
Contact Teledyne RESON Customer
Support if the problem persists.
Check input signal cabling.
Reboot the system.
Reboot the system.
Contact Teledyne RESON Customer
Support if the problem persists.
Check RAM or virtual memory
resources
Reboot sonar processor and try again.
Check previous alarms or warnings and
verify software installation.
Check previous alarms or warnings and
verify software installation.
Alarm Type
PCI Card
General System
Startup
Input Signal
(Timing and
Triggers)
Input Signal
(Timing and
Triggers)
Data Reading
Input Signal
(Timing and
Triggers)
General System
Startup
PCI Card
General System
Startup
General System
Startup
January 31, 2019