Teledyne SeaBat T Series Operator's Manual page 96

TROUBLESHOOTING
Message
Calibration Failed: Too much noise
Configure FPGA failed.
Could not create PCI server
Could not create TCP server
Could not create UDP server
Create TCP socket failed, code...
DMA Transfer Timeout. <x> of <x> bytes
received
Error creating non-sonar data reader thread
SeaBat T-Series Subsea Operator's Manual
Version 7
Description
Calibration has failed.
One or more of the processing cards
has failed to initialize or is non-
functional within the sonar processor.
Software detected a failure to configure
the main data acquisition and
distribution module (PCI). This can be
caused by errors in the configuration
files, or corrupted installation.
Indicates a network resource was
unavailable to the software from the
operating system.
Indicates a network resource was
unavailable to the software from the
operating system.
Operating system did not allow creating
of network resources.
This error generally indicates that the
uplink from the receiver is interrupted at
some point.
BITE module has failed to initialize.
Page 84
Action
Check BITE page and hardware and
cable installation to the receiver. Check
environmental noise. Contact Teledyne
RESON Customer Support.
Reboot sonar processor and try again.
Reboot the PC, call Teledyne RESON
support.
Check user permissions, network
drivers.
Check user permissions, network
drivers.
Check Windows installation, user
settings, and network resources.
Check the BITE page for receiver BITE
values. Restore factory defaults.
Reboot the PC. Check uplink cable
connections. Check temperature of the
SSP via BITE. Restore factory defaults.
Reboot the PC.
Check Windows installation and
resources.
Alarm Type
Calibration
PCI Card
General System
Startup
General System
Startup
General System
Startup
General System
Startup
Data Reading
General System
Startup
January 31, 2019