Figure 65: Ssp Pressure Bottle Connections - Teledyne SeaBat T Series Operator's Manual

INSTALLATION INSTRUCTIONS
To avoid damage to the system components, the SSP connections must be made according to
the labelling on the bottle:
SINGLE HEAD
 TX1:
Dual or single frequency, deep operation:
TC2160, 400kHz projector
or: Single frequency, deep operation:
TC2163, 200kHz projector
or: Dual frequency, shallow operation:
TC2181, 200-400kHz projector
 TX2:
Dual frequency, deep operation:
TC2163, 200kHz projector
 RX1:
EM7219-1, dual-frequency receiver
or: EM7218-1, dual-frequency receiver
To disconnect wet-end cables from the SSP, first unscrew the locking sleeves before pulling
the cables out.
Do not bend the cables beyond the recommended limits when positioning the cables. These
cables are very stiff, and a smaller bend radius will damage the cable.
Do not open the Fill valve (for Teledyne RESON use only). Noncompliance will affect
warranty situation (see Appendix G Warranty Information).
29 Dual head configurations with two SSPs are also available.
30 Not labelled on the bottle itself.
SeaBat T-Series Subsea Operator's Manual
Version 7
INTEGRATED DUAL HEAD
 TX1 and TX2,
or: TC2163, 200kHz projector
or: TC2181, 200-400kHz projector
 RX1 and RX2
or: EM7218-1, dual-frequency receiver

Figure 65: SSP Pressure Bottle Connections

CAUTION
CAUTION
CAUTION
Page 107
2 identical projectors:
TC2160, 400kHz projector
,
30
2 identical receivers:
EM7219-1, dual-frequency receiver
29
January 31, 2019