Pci Card Related (Admxrc) Errors - Teledyne SeaBat T Series Operator's Manual

TROUBLESHOOTING
Message
Error creating non-sonar data
reader thread
Failed to allocate memory for
ADMXRC read
Failed to allocate memory for
ADMXRC transfer
Failed to set up DMA Card 0
Failed to set up DMA Card 1
Internal 7k Center error
Internal error, 7kCenter NOT fully
operational
Inbound memory initialization failed
MMF Outbound memory creation
...
Required file: "7k_0.xml" or
"7k.xml" Not found.
Required file: "7k_Bite.htm" Not
found.
SET UP: FAILED TO LOAD BIT
FILE "XXX" for Device <x>,
Enumerator <x>
Socket initialization failed, error
code <x>
A.2.2 PCI Card Related (ADMXRC) Errors
The ADMXRC refers to the drivers that control the main processing unit within the sonar
processor. This processing card sits on the motherboards PCI bus and acts as a signal
processing layer between the hardware and software.
Message
2nd ADMXRC card not found
ADMXRC card not found, ERROR
=
ADMXRC.dll not found.
Configure FPGA failed.
Incorrect ADMXRC board found,
card_1
SeaBat T-Series Subsea Operator's Manual
Version 7
Description
BITE module has failed to
initialize.
The software could not
allocate enough system
memory to perform the
operation.
The software could not
access the processing card
device.
One or more startup
conditions have failed.
PC resources are
inadequate.
A critical startup configuration
file was missing.
Windows has failed to
allocate a network resource.
Description
One or more of the
processing cards has failed
to initialize or is non-
functional within the sonar
processor.
Page 77
Action
Check Windows
installation and
resources.
Make sure no other
software is running on
the sonar processor.
Reboot the system.
Check ADMXRC
drivers.
Check previous alarms
or warnings and verify
software installation.
Check RAM or virtual
memory resources
Reinstall the software.
Check network
permissions and
resources or Reinstall
operating system.
Action
Reboot sonar processor
and try again.
January 31, 2019