Verifying Or Changing The Computer Name And/Or Workgroup Name - Teledyne SeaBat T Series Operator's Manual

SYSTEM CONFIGURATION WITH USER INTERFACE

4.5.2 Verifying or Changing the Computer Name and/or Workgroup Name

If changing the Computer Name, a restart of the SSP is required before the
new name can take effect.
By factory default, the computer name of the SSP is set to SN+serial
number, which can be found on the serial number label next to the host
connector, as marked on the example label to the right.
Changing the computer name will prevent IP-address configuration from
the SUI (see appendix C.2 Change IP Configuration). For further
information on system configuration and user interface navigation, refer to
the RESON Sonar UI User Manual (see appendix E.1 SeaBat T-Series
Subsea Documentation).
The default workgroup name for the SSP is Workgroup and can be found on the network
workgroups. Use the following steps to verify or change the computer name and/or workgroup
name.
1. Establish a remote desktop session as described in section 4.4 above.
2. Once the remote desktop session has been established, go to the Windows Start
menu and select Control Panel.
3. Select System.
SeaBat T-Series Subsea Operator's Manual
Version 7
NOTE
CAUTION
Page 23 January 31, 2019