Input Signal (Timing And Triggers) Errors; Calibration Errors; Warning Messages; Configuration Warnings - Teledyne SeaBat T Series Operator's Manual

TROUBLESHOOTING
A.2.5 Input Signal (Timing and Triggers) Errors
Message
Failed to register external trigger,
ERROR =
Failed to unregister external trigger,
ERROR =
FIRMWARE does not support
External Trigger. Pinging is OFF
External triggering has failed.
Check/update software installation.
FATAL ERROR: PPS Timestamp
error Check 1 PPS input
A.2.6 Calibration Errors
Message
Calibration Failed: Too much noise
Calibration Failed: Over 10% dead
Rx channels.
Calibration Failed: Magnitude Error
Calibration Failed: Phase Error
Calibration Error: Calibration might
be invalid. Repeat the calibration.
A.3

Warning Messages

The warning messages listed in this section are accurate up to the document release date. For
a complete list of up-to-date warning messages, contact Teledyne RESON Customer Support
(reson-support@teledyne.com).
Warnings are marked with a yellow
A.3.1 Configuration Warnings
Message
7K Bite File cannot be Read
Cannot Read UDP Configuration
file <x> Error
Cannot Open or Create UDP
Configuration file
UDP Configuration file not available
SeaBat T-Series Subsea Operator's Manual
Version 7
Description
External Trigger Firmware
cannot be initialized or not
supported.
The pulse is not being
detected. Time stamping will
be done using system time
only. 1 millisecond accuracy
not possible.
Description
Calibration has failed.
NOTE
in the Messages pane.
Description
Software installation is
corrupt.
Page 79
Action
Reboot the system.
Contact Teledyne
RESON Customer
Support if the problem
persists.
Check input signal
cabling.
Action
Check BITE page and
hardware and cable
installation to the
receiver. Check
environmental noise.
Contact Teledyne
RESON Customer
Support.
Action
Restore factory defaults.
Reinstall software.
January 31, 2019