Appendix A Troubleshooting; System Error And Warning Messages; Error Messages; General System Startup Errors - Teledyne SeaBat T Series Operator's Manual

TROUBLESHOOTING
APPENDIX A TROUBLESHOOTING
A.1

System Error and Warning Messages

Most errors and warnings do not result in a system failure. In the case of repeated errors or
warnings, contact Teledyne RESON Customer Support (reson-support@teledyne.com).
This chapter contains a global list of error and warning messages generated by the 7k Center
software. The messages appear in the Messages pane of the Sonar UI.
For instructions on how to monitor the system, refer to the RESON Sonar UI User Manual (see
Appendix E Reference Documentation).
General information (no error/warning) is marked with an
A.2

Error Messages

The error messages listed in this section are accurate up to the document release date. For a
complete list of up-to-date error messages, contact Teledyne RESON Customer Support
(reson-support@teledyne.com).
Errors are marked with a red
A.2.1 General System Startup Errors
Message
ADMXRC configuration failed
Could not create UDP server
Could not create TCP server
Could not create PCI server
Error creating PCI Reader thread
Error creating PCI Copier thread
Create TCP socket failed, code...
SeaBat T-Series Subsea Operator's Manual
Version 7
NOTE
NOTE
in the Messages pane.
Description
The software failed to detect
or configure the primary
processing card.
Indicates a network resource
was unavailable to the
software from the operating
system.
Software detected a failure to
configure the main data
acquisition and distribution
module (PCI). This can be
caused by errors in the
configuration files, or
corrupted installation.
Operating system did not
allow creating of network
resources.
Page 76
in the Messages pane.
Action
Check PCI bus drivers
for ADMXRC card.
Check user
permissions, network
drivers.
Reboot the PC, call
Teledyne RESON
support.
Check Windows
installation, user
settings, and network
resources.
January 31, 2019