Teledyne SeaBat T Series Operator's Manual page 97

TROUBLESHOOTING
Message
Error creating PCI Copier thread
Error creating PCI Reader thread
Error starting <name> thread
External triggering has failed. Check/update
software installation.
Failed to allocate memory for ADMXRC
read.
Failed to allocate memory for ADMXRC
transfer.
Failed to allocate memory for ADMXRC
transfer.
Failed to configure 1st FPGA with <x>,
ERROR =
SeaBat T-Series Subsea Operator's Manual
Version 7
Description
Software detected a failure to configure
the main data acquisition and
distribution module (PCI). This can be
caused by errors in the configuration
files, or corrupted installation.
Software detected a failure to configure
the main data acquisition and
distribution module (PCI). This can be
caused by errors in the configuration
files, or corrupted installation.
A module has failed to start correctly.
External Trigger Firmware cannot be
initialized or not supported
The software could not allocate enough
system memory to perform the
operation.
The software could not allocate enough
system memory to perform the
operation.
One or more of the processing cards
has failed to initialize or is non-
functional within the sonar processor.
One or more of the processing cards
has failed to initialize or is non-
functional within the sonar processor.
Page 85
Action
Reboot the PC, call Teledyne RESON
support.
Reboot the PC, call Teledyne RESON
support.
Reboot the system.
Reboot the system.
Contact Teledyne RESON Customer
Support if the problem persists.
Make sure no other software is running
on the sonar processor. Reboot the
system.
Make sure no other software is running
on the sonar processor. Reboot the
system.
Reboot sonar processor and try again.
Reboot sonar processor and try again.
Alarm Type
General System
Startup
General System
Startup
System Resource
Input Signal
(Timing and
Triggers)
General System
Startup
General System
Startup
PCI Card
PCI Card
January 31, 2019