To Program A Job To Use Multiple Stocks; Adding Pages To Your Document With The Sfm Insertion Module; To Add Sheets With The Sfm Insertion Module - Xerox Nuvera User Manual

To program a job to use multiple stocks

Note
Make sure the paper trays are configured with the correct stocks. If you attempt to program a multi-stock
job without the required stocks loaded, the system will generate a series of system alerts prompting you
to load required stocks, slowing your productivity. See
1. Set the properties for a job on the Xerox Nuvera user interface. See
your Document for details.
2. Program papers trays with all stocks (cover stock, tabs, 8.5 x 11 white, 8.5 x 11 blue) necessary to
process the job.
3. Follow the procedure for
4. In the user interface, click Print.
Adding Pages to your Document with the SFM
Insertion Module
The SFM Insertion Module is either a 2-Tray or 4-Tray Sheet Feed Module used as a post-process inserter
(pages do not go through the print engine). Use the SFM Insertion Module to add covers, inserts, or slip
sheets to your documents. The SFM Insertion Module fits between the print engine (or, if applicable to
your configuration, the Sheet Enhancement Module) and the finishing device.
Note
To learn how to insert covers, preprinted tabs or colored paper into your job using the Insertion Module
on the Multifunction Finisher (MFF) Pro Plus, refer to
The addition of the SFM Insertion Module does not affect production speeds since covers and inserts
are merged into the paper path after marking takes place, without requiring a gap in the pitch. For more
information, see a description of

To Add Sheets with the SFM Insertion Module

Pick a stock that is loaded in the SFM Insertion Module, and program that on a blank insert sheet or
cover (through the Special Pages dialog).
The system should feed blank sheets from the SFM Insertion Module whenever possible.
Note
Page insertion with the SFM Insertion Module may not occur when there is a blank page in the actual
document. The system software does not detect blank pages embedded in documents, and will not
trigger page insertion.
Alternatively, both of the SFM Insertion Module feed bins can be loaded with the same stock, allowing
continuous uninterrupted production insertion of pre-printed stocks and the addition of photographs
and other sensitive documents that normally could be damaged by heat from the fuser section of the
printer.
Xerox ® Nuvera ®
User Guide and Training Aid (UGTA)
Adding Pages to a Document.
About Pitch.
Paper Tray Programming.
Copying your Document
Using the Multifunction Finisher (MFF) Pro
Setting Up Complex Jobs
or Printing
Plus.
12-21