Xerox Nuvera User Manual page 201

Subtopic
Copy job with imposition / annotation
Duplex front to back alignment
Fault caused by modified attribute
Imposition functions with Copy MSO / Build Job
Percent complete
R/E with Scan to File
PDF with Rotated Thumbnails
Xerox ® Nuvera ®
User Guide and Training Aid (UGTA)
Hint/Tip Description
If a copy job with Imposition is held, modified to not
have imposition, then released, the output will not be
scaled properly. If a copy job with Imposition is saved,
the saved ticket will not reflect the correct imposition
attribute (instead it will show 'None') however the job
will reprint with the correct imposition. If a copy job with
Annotation is saved, the saved ticket will not reflect the
correct annotation attribute (instead it will show 'None')
however the job will reprint with the correct annotation.
If an image size is less than the output paper size, and
the image is duplex copied, the images will not align
from front to back. Perform an image shift on one of
the sides, or use Auto Center to get them to align.
If you hold or proof a copy job and modify an attribute
that will cause it to fault (ex. request an unsupported
staple) the job will go aborted and you will need to res-
can the job. As a work around, save the job and then
when you print it, if it faults, you can change the offend-
ing attribute, and then release it.
Do not use imposition functions on Copy Mixed Size
Original (MSO) or Build Jobs that contain multiple sizes,
or the output will be unpredictable. This includes any
jobs that were held or saved and have more than 1 paper
size. If you use Build Job with Signatures (Booklets), all
of the segments must be the same size and orientation.
If you scan in long edge feed on the SDDF, you must
also scan in long edge feed on the platen. You must also
have the same output stock selected for each segment.
When sending a booklet layout copy job, the Percent
complete increments half as fast as the job completes.
If you are using Scan to File and you are using the sys-
tem supplied Reduce/Enlarge rates, the saved job ticket
will have a custom stock size. For example, a Scan to File
job with a RE value of 64% (Ledger > Letter) will save
a job with a custom size rather than Letter. If you try to
reprint it, you will need to choose Letter stock. If you
would like the saved job to come out to exactly the cor-
rect size for reprinting, use Copy Save instead of Scan
to File.
Saved PDF files contain thumbnail images that can be
displayed by Acrobat Reader. When viewing a PDF file
saved from Scan to File, those images are rotated 90
degrees clockwise from the orientation of the full-size
page images.
How Do I...
14-77