Systems With Sfm Insertion Module And Mff Professional; Systems With Mff Pro Plus Only - Xerox Nuvera User Manual

Special Case: Jobs with drilled paper AND drilled tabs when using the MFF
When processing jobs which use drilled paper and drilled tabs together, load the tabbed stock with tabs
trailing as usual, but load the drilled paper stock with the holes leading. This is contrary to what the label
on the tray depicts, but drilled stock must be loaded this way in order to achieve correct output. If the
job includes drilled tabs or drilled paper, but not within the same job, follow the diagram on the tray
label and/or the information in the table above.

Systems with SFM Insertion Module and MFF Professional

Note
No tabs can be loaded into an SFM Insertion Module (if present) if using a Multifunction Finisher.
Stock Type
Drilled paper
Labels
Tabs
Preprinted stock
Transparencies
Ordered stock

Systems with MFF Pro Plus ONLY

Stock Type
Drilled paper**
Xerox ® Nuvera ®
User Guide and Training Aid (UGTA)
Loading
Trays 1 and 2
Trays 3 and 4
Trays 1 and 2
Trays 3 and 4
Trays 1 and 2
Trays 3 and 4
Trays 1 and 2
Trays 3 and 4
Trays 1 and 2
Trays 3 and 4
Trays 1 and 2
Trays 3 and 4
Loading
Trays 1 and 2
Trays 3 and 4
Insertion Tray
Setup Paper Trays
Holes trailing
Holes trailing
Label side up
Label side up
Tabs trailing (loaded into pre-fuser
FM only)
Tabs trailing (loaded into pre-fuser
FM only)
Face up, right edge leading
Face up, right edge leading
Tape edge trailing
Tape edge trailing
Face up, right edge leading, 1-N order
Face up, right edge leading, 1-N or-
der
Holes trailing
Holes trailing
Holes trailing
11-9