Xerox Nuvera User Manual page 163

Related Hints and Tips
Subtopic
Job fault after switching queues
PCL driver and paper size
Percent complete indicator
Print to File with DocuTech emulation
Staple print with two stock sizes
Tab job landscape with tabs at top
Tab job with drilled paper (MFF configs. only)
When paper runs out, do not restart or shut down
Xerox ® Nuvera ®
User Guide and Training Aid (UGTA)
Hint/Tip Description
If a job faults after moving it from one queue to another,
and the fault indicates something to the effect that
queue attributes are corrupted, and that a restart is re-
quired, yet a restart does not solve the problem, the
cause is likely that the job's paper size is in conflict with
the programming attributes of the queue. For example,
the job may contain paper sizes that are not supported
by the output destination programmed in the queue.
FreeFlow Print Server will display the "queue default
paper size" for the paper size of jobs sent from the PCL
driver. The same will happen for PS jobs sent using a
custom paper size. The job will print on the correct size
paper in both cases. This is just a display issue.
For very long jobs, the percent complete indicator may
not be correct. Use the Pages Printed indicator to mon-
itor job progress against the known size of the job.
If you want to Print To File a PS or PDF job with Doc-
uTech Emulation enabled, select a save type of PDF. You
will then be able to reprint the job with DocuTech Emu-
lation enabled and the job will print as expected.
If you want to staple print a job that requires two sizes
of SEF stocks, and one of them is also loaded LEF, pro-
gram both the stocks that you want to use with the same
custom Type. When sending the job, select the custom
Type and the job will use the correct paper and staple.
If you do not do this, the job will fault because it will
attempt to use LEF paper and won't be able to staple.
When submitting a landscape job that contains tabs
running across the top, enable the 180 rotate option to
get the proper orientation of the image on the tabs.
For MFF configurations only: When running a tab job
with pre-drilled paper for the main body pages, the pre-
drilled paper must be loaded with the holes leading,
which is opposite of what the label on the tray indicates.
When printing a job, if it runs out of paper, do not re-
start/shutdown the machine. If you do, the job may re-
sume on the wrong orientation paper. Example: If your
job was printing on Letter LEF and ran out, the system
was restarted, the job may resume printing on Letter
SEF. As a work around, disable any trays of the wrong
orientation before the restart/shutdown or fill the correct
tray before the restart/power up completes.
How Do I...
14-39