Table of Contents
Advertisement
How Do I...
Subtopic
Scan jobs do not set Print with override
Stapling option displayed on UI
Scan to Network Job Fault
Imposition and a Copy job
Build Job and stapling
Build Job with image orientation
Copies in document handler
14-76
Hint/Tip Description
Scan jobs can only be directed to the default queue. Do
not set the disposition to "Print" with "override" also set.
This will disable Image Save since those jobs will always
print instead. This also causes Mixed Size Original (MSO)
jobs not to run because a fault will always appear re-
questing the stock to be loaded even if it is properly
loaded.
When setting up and saving a copy job with stapling,
the resulting stapling choice for the saved job may not
match what was originally programmed. The UI may
display an equivalent stapling selection but the job will
apply the proper stapling location. This applies to the
following: "1 Staple Landscape Right" displays as "1
Staple Portrait Left". Setting a job with 2 staples portrait
right results in the job being saved with 2 staples land-
scape bottom, and similarly: 2 staples portrait left results
in 2 staples landscape top. 2 staples landscape left res-
ults in 2 staples portrait top. 2 staples landscape right
results in 2 staples portrait bottom.
If a large scan to network job faults, when the fault is
cleared it may appear that the job is stuck in a
"Scheduling" state. In fact the job is active, but it takes
a long time to reach the "Being Saved" state (approxim-
ately 40-60 seconds per each 100Mb).
If you are using imposition on a Copy job, the R/E setting
on the Basic Tab will be ignored by the system. This is
because the imposition feature you select will determine
the actual R/E to use. Note: If you use Custom Multiple-
Up, you will be able to choose the R/E value yourself.
When using Build Job and trying to staple Letter and
Legal, disable any Letter Long Edge Feed trays to prevent
a programming conflict.
When using Build Job with Imposition (ex. booklet), with
all Landscape images, and scanning from the platen,
rotate the paper 180 degrees on the platen to get the
proper output.
When making copies, ensure the documents are in the
document handler for at least 1 second before pressing
the start button.
User Guide and Training Aid (UGTA)
Xerox
®
Nuvera
®
Advertisement
Table of Contents
